The bracing link comes off the bottom of the square stock, under the sway.
Apr 18, Burn it out. Light the bastard on fire, let it simmer until the bushing and sleeve separate and the bushing element is shrubremover.bar take about minutes. Then take a socket that fits the ID and knock out the outer bushing sleeve.
Clean up the bore and install new bushing, good to shrubremover.barted Reading Time: 4 mins. Adjustable bars will have a sleeve, so you don't have to remove the track bar ends. You'll want the adjustable end at the axle side. As far as adjusting your new track bar is concerned, does one tire stick out of the wheel well/fender more than the other (usually driver’s side)?
If you're unsure, measure the distance from the tub or suspension, something solid and equal on both sides to the outside edge of.
Oct 25, Removing the front track bar was the only way I could get my YJ to flex with a SUA setup. With a SUA setup running a total of 9" of lift I got the front tires (33s) to rub the fenders without the track bar. However the downside to removing the track bar. Jan 03, After ensuring you have no burrs inside the track bar, smear the Energy Suspension grease in there.
Use a round file if necessary to de-burr the track bar. Press the bushings into the track bar.
The next step is ensuring proper stabilization of the steering linkage.
Lubricate the inner sleeve, and press it in. We used a hammer to finish seating the sleeve.
Reinstall the axle end of the track bar. Address: Via CallejonSan Clemente, CA Nov 25, Re: Removing control arm bushings (axle side) From past experience with control arm bushings, it's just bull work that is held up by our old friend s, rust and corrosion we are no stranger too.
A little penetrating oil daily until the day chosen to attack again will help and should achieve success. Rubicon Express Front Track Bar Bushing Kit with 10mm Bolt.
First of all, the mount requires a swaybar connector that is either stock, uses one of theirs that leaves the lower mount in place.
Synergy Manufacturing Dual Durometer Track Bar Bushing 9/16" 14mm.Prothane Rear Track Bar Bushing Kit for Jeep Wrangler JK.More choices available. Energy Suspension Front Track Bar Bushing Set for Jeep Wrangler TJ.5/5.